A consignment of EIM single-row cylindrical roller bearings for a turbine application reached the designated port in Indonesia on May 29, 2026. The customer had specified P5 accuracy and a machined solid brass cage.
What the turbine drawing specified
The March 24 inquiry included assembly drawings and identified speed, temperature and vibration as operating concerns. EIM reviewed the cage design and machining tolerances with the customer before the order was confirmed on April 30. The close-up shows the cage between the rings, with its pockets spacing the cylindrical rollers around the bearing.

The inspection team checked radial runout, end-face runout and freedom of rotation before packing. For a buyer ordering a replacement, the cage specification belongs on the inquiry alongside the accuracy class. Both were part of the configuration agreed for this turbine.

From Dalian to the Indonesian port
The packing team wrapped the bearings in rust-preventive film, added cushioning and secured them in reinforced wooden frames. The consignment left Dalian for Tianjin on May 17. At Tianjin it traveled as less-than-container-load (LCL) ocean freight alongside other goods purchased by the customer. EIM coordinated the inspection reports and customs documents for the shipment.
For a comparable turbine bearing, include the assembly drawing revision, cage requirement, operating speed and temperature range in your bearing inquiry.
Need to verify a bearing for your equipment?
Send the complete model designation or drawing, load conditions, speed, quantity and other critical requirements.




