The shipment record for an EIM Bearing order to Denmark covers gearless slewing ring bearings intended for photovoltaic (PV) or concentrated solar power (CSP) tracking support bases. The main fit questions were the specified ring dimensions, geometric tolerances and mounting-hole pitch-circle layout.
Matching the solar-tracker mounting interface
Before production, the engineering team reviewed the customer’s drawings, including inner and outer diameters, overall height, hole diameters, counterbores and angular positioning of the bolt-hole pattern. These details matter because a slewing ring must match the stationary base and rotating support without forcing the mounting interfaces.

Inspection and protection before dispatch
The supplied delivery record states that dimensional and geometric features, including the pitch circle diameter (PCD) hole layout, were rechecked and that inspection documents accompanied the order. The original inspection reports and measured values were not included in this photo set, so this article does not claim particular measured tolerances or test results.
The workshop photographs show the finished rings supported and protected while being prepared for handling. The shipping record also describes rust-prevention measures, cushioning and wooden export crates. Keeping ring surfaces and bolt-hole interfaces protected is important for subsequent assembly and alignment.

Shipment milestones to Denmark
- October 23, 2026: final inspection and factory release recorded.
- October 29, 2026: arrival at Qingdao Port and consolidation with other freight recorded.
- November 3, 2026: ocean-vessel departure for Denmark recorded in the supplied shipment account.
These milestones are taken from the supplied delivery notes rather than inferred from workshop photos. The destination delivery or customer acceptance has not been documented here.

Information to send for a similar bearing
For a gearless slewing ring used in a solar-tracker base, include a dimensioned assembly drawing, inner and outer diameters, mounting PCD and hole locations, bolt details, expected axial/radial loads and moment, operating environment, required quantities and inspection requirements.
See EIM’s slewing ring bearing range or send an application inquiry with the relevant drawings and specifications.
Need to verify a bearing for your equipment?
Send the complete model designation or drawing, load conditions, speed, quantity and other critical requirements.



